FORD PERFORMANCE BILLET THROTTLE BODY - 2005-2010 MUSTANG GT

Upgrade your 55mm Dual Throttle Body on your Mustang GT 4.6L 3V, to this twin 62mm Billet Throttle Body from Ford Racing.  Fits in the factory location on 2005-10 Mustang GT.  Fully assembled, complete with throttle position sensor and actuator motor, ready to bolt on!  Uses OE gears to prevent gear bind and wear common with other aftermarket throttle bodies.  

Comes completely assembled with all factory sensors installed.  No need to tear apart your original throttle body.  Electronic throttle control was introduced on the Mustang in 2005. It's introduction has made attention to detail and setup of replacement throttle bodies even more critical than in the past.  Calibrated for idle air flow using the same procedure as production throttle bodies.  Precision billet construction with tapered inlet for consistent high flow.  Polished to perfection and the CNC'd Ford Racing logo, provide a clean element of beauty, along with it's horsepower increase.  (CFM Rating: 1306cfm vs 953cfm Stock)* 

*All cfm ratings are calibrated at 28-inches of water, measured on SuperFlow SF-1020 Flow Bench.  

NOTE: Requires Livernois Motorsports Performance Tune. 

About Livernois Motorsports

Livernois Motorsports & Engineering has become best-known for revolutionary tuning and high-end performance products for late model Ford, Mopar and GM vehicles. The company is proud of its deep roots in the automotive and motorsports industry dating back to its original founding in 1949. Since then the company has expanded its product line to include tuning and performance components for desert racing, SCCA and drag racing. Livernois Motorsports is proud to engineer, test and manufacture its products in the USA.